8-1
5 - DA
S
H
/
A
U
T
O
SECTION 8 – ENTERTAINMENT
HDMI VIDEO SELECTION
SYSTEM
The HDMI Video Selection System allows
you to watch high definition video from multiple
sources on multiple TV’s at the same time.
TVs connected to this system are:
• Output A - Lounge TV
• Output B - Bedroom TV
• Output C - Exterior Entertainment Center TV
• Output D - 2nd Lounge TV/Bathroom (if
equipped)
You can select either:
• 1 = Blu-ray
• 2 = Satellite Receiver 1
• 3 = Satellite Receiver 2
• 4 = Auxiliary (Dash Radio House Mode).
All TV’s and A/V sources operate from 120-
volt AC household current only, so you must
have either the shoreline connected, the generator
running, or the inverter turned on (if equipped).
NOTE: Green lights that are illuminated on the
HDMI Video Selection System indicate
that video sources are active.
NOTE: There will be a slight delay when
changing sources. Winnebago
Industries
®
recommends setting each
component to a maximum video output
resolution of 1080i for proper operation.
Select Video Source and TV
•
Power “ON” TV, HDMI Video Selection
System, TV, Sound Bar (if desired), and Video
source (DVD player, Satellite receiver(s), or
Dash radio).
•
Press and release button for desired TV
viewing (e.g. “Output B” for bedroom TV)
until the number is lit for the desired source
(e.g. Blu-Ray).
•
At the TV, ensure the source (or input) is set to
HDMI.
Infrared Emitters
The HDMI Video Selection System in your
motorhome is also featured with Infrared
Emitters (connected to both Accessory
Connection Cables), which are used to extend the
remote control from all TV’s in the motorhome to
either Satellite 1 or Satellite 2. Install Infrared
Emitter by removing the protective cover from
adhesive and place directly in front of the I.E.
Receiver on the component.
Connecting Satellite Dish Receiver
•
Connect Satellite Receiver to the Accessory
Connection Cable (Satellite Receiver 1 or 2.)
These cables are located in a front overhead
cabinet.
HDMI Video Selection System
(Located in front passenger overhead cabinet)
HDMI Video Selector
Control
(Located in your InfoCase
Box)
• Used to control main
HDMI Video
Selection System only.
HDMI Video
Selection
System
• Infrared Emitter
Accessory Connection
Cables
* Satellite Receiver 1
and Satellite Receiver 2