7-17
SECTION 7 –
PLUMBING
WINTERIZING OPTIONAL
APPLIANCES
Winterizing Washer/Dryer
(Stackable)
–If Equipped
Method 1 – Drain Water
If you have decided to completely drain the
motorhome waterlines, follow these steps to
winterize your Washer/Dryer:
1. With the Washer/Dryer power OFF, pour 1/2
quart of RV-type antifreeze into the Washer
drum.
2. Close door. Advance Cycle Selector to “B”.
3. Press ON/OFF button, then press START. Let
the Washer/Dryer run for 1 to 2 minutes.
4. Press ON/OFF button to turn power OFF.
5. Unplug Washer/Dryer from electrical outlet
(or disconnect power).
6. Turn Water Supply Faucets OFF. Disconnect
inlet hoses from faucets.
7. Drain remaining water from hoses. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer’s user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into “Compartment 2” inside
Dispenser Drawer.
4. Advance Cycle Selector to “Position 4”.
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.
Method 2 – Fill with RV Antifreeze
If you have decided to fill the motorhome
waterlines with RV antifreeze, follow these steps
to winterize your Washer/Dryer:
1. With machine power OFF, advance Cycle
Selector to “Position 3”.
2. Press ON/OFF button, set water temperature
to WARM, then press START. Let machine
fill until the drum turns (this could take up to
1 to 2 minutes).
3. Press ON/OFF button to turn power OFF.
4. Advance Cycle Selector to “B”.
5. Press ON/OFF button, then press START.
6. After letting antifreeze drain completely from
drum, press the ON/OFF button to turn power
OFF. Finished.
7. Turn Water Supply Faucets OFF. Disconnect
inlet hoses from faucets.
8. Drain remaining water from hoses. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer’s user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into “Compartment 2” inside
Dispenser Drawer.
4. Advance Cycle Selector to “Position 4”.
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.