SECTION 5 –
APPLIANCES AND SYSTEMS
5-10
THERMOSTAT
(Heating and Cooling)
The Electronic Thermostat (located on the
monitor panel) controls the Hydronic Heating
system, as well as the roof air conditioners in
your motorhome.
When controlling the settings from the
Thermostat, you must manually press the Zone
Button and set to your preference by toggling to
either Zone 1, Zone 2, Zone 3, or all zones
simultaneously.
Roof Air Conditioners
The N34 and N36 have 2, and the N40 has 3
AC units.
•
REAR - (1) A/C Unit in Bedroom/Bath Area
•
MID (if equipped)- (1) A/C Unit in Living/
Galley Area
•
FRONT - (1) A/C Unit in Front Cab Area
The Thermostat system will operate in both
heat and cool modes, but will not allow you to
run both heat and cool modes simultaneously.
Auto Mode allows you to set both a “Cool”
temperature and a “Heat” temperature to
automatically maintain a desired comfort
temperature.
•
Select the desired heat source.
•
Fan speed can be selected.
•
Settings are shared between bedroom and
lounge to ensure that A/C and Heat Pump
cannot be run at the same time.
Heat
The lounge heating mode is controlled by the
“Mid” temperature setting.
1. Select the desired temperature on the temp
bar.
2. Under the desired area of the motorhome
(Front, Rear, or Bay) use button to toggle to
Aqua-Hot zone heat mode.
3. The Heating system will default to “Heat
Pump”. Select the AquaHot Power Source
(either Diesel Heat or Electric Heat) if
desired.
Floor Heat
The Floor Heat selector is in the lower right of
the Climate screen. This heats the floor, and the
status is displayed on the selector.
Cool
The lounge cooling mode allows independent
temperature settings between the Front A/C and
Middle A/C.
1. Select “Cool” mode.
2. Under the desired area of the motorhome
(bedroom, mid, or front) use button to toggle
to “Cool” mode.
3. Adjust the temperature.
4. Select the fan speed of your choice (High,
Low, or Auto).
Auto
Auto allows you to set both a “Cool”
temperature and a “Heat” temperature to
automatically maintain a desired comfort
temperature.
•
Select the desired heat source.
•
Select the Fan Speed.
•
Settings are shared between Bedroom and
Lounge to ensure that A/C and Heat Pump
cannot be run at the same time.
Thermostat “Climate” Screen
(Located on Multiplex Monitor Panel)
