SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-2
SLIDEOUT ROOM OPERATION
(HWH)– ELECTRIC
-If Equipped
Slideout rooms provide a spacious living area
at the push of a button.
NOTE: Your motorhome may have one or more
slideout switches depending on model,
options, and available equipment.
The slideout room system uses 12-volt DC
motorized mechanisms with an electronic control
system to provide smooth operation and positive
weather seal.
NOTE: We recommend that you KEEP THE
ENGINE RUNNING WHILE
EXTENDING OR RETRACTING
SLIDEOUT ROOMS so the engine
alternator can provide maximum power
for proper operation of the slideout
mechanisms. After initially starting a
cold diesel engine the engine preheat
grid may cycle on and off for up to 90
seconds, the cycling of the preheat grid
will result in a momentary drop in
chassis battery voltage that may cause a
low voltage error in the slideout or
leveling controller. If this happens, wait
until the preheat grid is no longer cycling
to operate your slide room and leveling
jacks.
WARNING
Your motorhome may have more than
one slideout room. Understand which
switch operates which slideout room prior
to operation. Make sure all slideout rooms
are clear of people who could be harmed
or obstacles that could cause damage
prior to operating any slideout rooms.
Failure to observe can result in death or
serious injury.
CAUTION
Never drive the vehicle with a slideout
room extended!
Slideout Switches
(Located above entrance door)
-Typical View
WARNING
CRUSH HAZARD. Keep people and
objects clear of the inside and outside of
the slideout room when operating. Failure
to comply could result in death or serious
injury.
Slideout Switches
(Located on the monitor panel
)
-Typical View
