Version
2
01.03.2017
10
2.3
CONNECTION
2.3.1
Removing the plastic cover
In order to install the air conditioner, remove the plastic cover on outside. Remove the 3 screws on the
top and below.
2.3.2 Setting up the device
Be sure to center the air conditioner properly in the wood frame. Contact between the sheet and the
frame would cause vibrations that could be reflected in the house.
- Fix the air conditioner with the 3 wood screws and washers.
- Exit through the round hole on the left of the compressor, the outlet and the water drain pipe.
- Refit the cover.
Important :
After transport or maintenance, wait for 24 hours before switching
on the air conditioner.
3
USING THE AIR CONDITIONER WINEMASTER
®
- Connect the plug
- Take out the drain hose. It must be straight and its end must not dive into the water
- Switch the IOII knob to the requested speed
The thermostat indicates the temperature in the wine cellar with a precision of 2 ° C. A temperature
change of the air does not mean the same change of temperature of the liquid due to the thermal ca-
pacity of the liquid. The temperature is set at 12 ° C in the factory. When starting using the air condi-
tioner, it is advisable to check and, if necessary, modify this temperature by following the procedure
below.
- Wait a few minutes until the compressor starts.
During the first use and for large cellar volumes, it is advisable to use the "booster" position of the cel-
lar's internal ventilation. After a few hours, you can go back to the normal fan speed by setting the
IOII switch to position I.
3.1
Connecting the air conditioner WINE C50S / C50SR
When you plug the unit to the electrical socket :
-
the fan inside the wine cellar starts up immediately ( permanent « no frost » ventilation )
-
If the cellar temperature
≥
to the thermostat setting : the compressor starts after 2 minutes
-
If the cellar temperature
≤
to the thermostat setting: the fan doesn’t start.
The power outlet must be accessible after installation
.
