6
WARNING:
DO NOT remove the screws around
the edge of the transition plate or the screws on
the top side of the turret assembly; these areas
are marked in red on the image below.
C) Remove two coax cables with the
7/16" wrench. Gently pull the GPS
cable to disconnect from ODU. Once
removed, cut the zip tie located on
the rubber grommet, then pull the
grommet away from the housing.
WARNING:
Do NOT cut any cables
when cutting zip tie.
B) Remove four 5/16" screws from
the ODU with the provided 5/16"
nut driver (Figure 8).
Figure 7
Figure 8
Figure 9
Turret assembly
Transition plate
Base
coax cables
zip tie
GPS cable
4. Motor Mount Removal
A) Remove the nine 5/16"
screws around the edge of
the transition plate (Figure
7). Once removed, flip over
the turret top and remove the
plastic base seal and gasket,
giving you access to the
electronics.
Screws
