4
2. Reflector Removal
Once the IDU has been powered off and the data cable and
power cord have been disconnected you will need to get
on top of the coach. The tools needed are a ½" and 7/16"
wrench, 3/16" Allen wrench, adjustable wrench, and the
provided 5/16" nut driver.
NOTE:
Images shown are for reference only, your
unit should be resting on the hardstop – Notice the
“
PINCH POINT!
” label.
A) To remove the reflector you start with removing the ½"
nuts from the back of the reflector (Figure 1) using a ½"
wrench. You may also need to use the 3/16" Allen wrench
on the front of the reflector to assist you with the removal.
Once the two longer screws have been removed you can
now remove the wedge shaped clamps.
B) Proceed to removing the lower ½" screws on the reflector
bracket. Once removed, you can remove the coax cables
with a 7/16" wrench (Figure 2) and the P-Clip (Figure 3)
with the provided 5/16" nut driver.
Figure 1
Figure 2
Figure 3
