7. Install Reflector, LNBF
and
Feed Arm
A) Insert the two longer screws into the top two holes in the
front of the reflector.
B) Slide a wedge-shaped clamp onto each screw sticking out
the back of the reflector (Figure 21).
C) Thread a nut onto each screw; make sure the nut is tight
to keep the clamp from falling.
D) Align the two anchor posts on the back of the reflector
with the two notches in the skew plate (Figure 22). Then,
set the reflector on the skew plate; the reflector should be
positioned with the LNB arm at the bottom of the plate.
Carefully use the clamps on the back of the reflector to
hold the reflector in place (Figure 23); make sure that the
thicker part of the clamp is to the outside of the reflector.
E) Once the top screws and clamps are in place, install the
lower screws and clamps.
F) With the bracket mounted securely, connect the four coax
cables to the mount (Figure 24).
G) Locate the cable tie on the coax cables that you just
connected to the mount. Place the p-clamp on the cables
so that it is just below this cable tie. If the cable tie
is missing, install the clamp 14” from the end of the
connectors.
H) Carefully screw this clamp to the front of the lift arm
using the provided 5/16" screw (Figure 25).
WARNING:
Be careful not to strip out the hole for the
5/16” screw when replacing the clamp holding the
coax cables to the arm. Do not use a power tool. Do not
overtighten this screw.
10
Figure 25
Figure 24
Figure 23
Figure 21
Figure 22
Notches in
skew plate
Anchor posts
in reflector
