MACHINE OPERATION
QUICK 98560 09/20/99
3-8
!
WARNING
PRE-RUN MACHINE INSPECTION
Do a pre-run inspection to find problems that could
cause poor performance or lost time from breakdown.
Follow the same procedure each time to avoid
missing steps.
NOTE: See maintenance section for pre-run machine
inspection checklist items.
STARTING MACHINE
NOTE: Perform pre-run machine inspection before
operating machine.
FOR SAFETY: Before starting machine, make
sure that all safety devices are in place and
operating properly.
1. The operator should be in the seat with the left
foot on the brake pedal or with the parking brake
on. The directional pedal must be in the neutral
position to avoid unintentional movement. There
is a built in safety to disable the drive system if
the key is turned on with the directional pedal
engaged. The directional pedal must go back to
neutral before the machine will move.
NOTE: The operator must be in position on the seat
in order to activate any machine functions.
2. Turn the key switch clockwise to the
“ON”
position.
3. Release the brake, then press lightly on the
directional pedal in the desired direction and
drive to the filling area.
EMERGENCY STOP PROCEDURE
1. Turn key to off position. If an electrical problem
is suspected push in emergency stop button to
remove all power from machine.
2. Release pressure on directional pedal.
3. Apply
brakes.
NOTE: Turning the key switch off during normal
running operation will stop all motors and lift
actuators. When the key is turned back on the
systems will assume they are in the normal parked
mode (scrub deck up, squeegee up, and motors off).
Any switch command will send the selected system
to the working position regardless of the position it
was in when the key switch was turned off. Two
touches of the respective switch are required to raise
the scrub deck and squeegee and turn off motors.
This is normal. No damage to the machine will result.
FILLING THE QUICK
©
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, set parking brake,
turn off machine and remove key.
1. Set squeegee and scrub deck to up position, set
parking brake, and turn off key switch.
2. Remove solution tank cover.
Flammable materials can
cause an explosion or fire.
Do not use flammable materials in the tanks.
3. Fill the solution tank with clean water, 5” from the
bottom of the fill inlet. At this level the solution
tank contains 25 gallons (97.5 liters). The water
must not be hotter than 140ºF (60ºC) to prevent
damage to the tank.
4. Measure the required amount of chemical into
the solution tank. Liquid chemicals should be
added to the solution tank after filling with water.
Dry chemicals should be thoroughly mixed before
being added into solution tank. Commercially
available, high alkaline cleaners, specifically
manufactured for floor cleaning are suitable for
use in the
QUICK©
solution system.
NOTE: Read the chemical manufacturers
recommended proportions instructions and
application instructions.
5. Inspect solution tank cover vent for obstructions.
A blocked vent will prevent proper flow of solution
form reaching the scrub deck.
6. Replace solution tank cover.
