CONTROLS
QUICK 98560 09/20/99
3-6
I.
EMERGENCY STOP BUTTON
The emergency stop switch controls all battery power
to the machine. In an emergency that requires quick
disconnection of the batteries, push down firmly on
the red knob.
NOTE: The emergency disconnect should only be
used for emergencies and service. Repeated non-
essential use well shorten the life of the connector.
Also, when all power is removed from the machine
the battery condition meter resets to a less than
accurate full charge position when power to restored.
J. HOUR
METER
The hour meter located at the rear of the touch panel
records the number of hours the machine has been in
operation with the scrub brushes running. This
information is useful in determining when to service
the machine
K. BATTERY CONDITION INDICATOR
The battery condition 6 LED’s indicated the present
charge of the battery. When only the LED near the
left side of the gauge is on, the batteries should be
recharged. Further operation of the machine could
damage the machine or batteries. The LED second
from left indicates 80% discharge signaling ideal time
to recharge batteries. The remaining 4 LED’s
indicate the approximate charge level of the batteries.
When the machine is left overnight with less than a
full charge, the display may initially indicate a full
charge. It will also indicate a full charge if the
batteries are disconnected, than reconnected. After
a few minutes of operation the gauge will give the
correct charge level.
NOTE: See “Batteries” in maintenance section for
more information on battery maintenance.
L. STEERING
WHEEL
The steering wheel turns the front wheels of the
machine causing the machine to turn.
M. HORN BUTTON
The horn button is located at the bottom of the touch
panel. The horn is activated by pressing the horn
button.
N. CIRCUIT
BREAKERS
The circuit breakers are circuit protection devices
designed to interrupt the flow of current in the event
of an electrical overload. When tripped, the circuit
breaker must be reset by pressing the exposed
button on the face of the affected circuit breaker. All
circuit breakers are located on the right side of the
electrical panel. If the circuit breaker continues to
trip, the cause of the electrical overload should be
found and corrected.
The following chart shows the circuit breakers and
fuses with the components they protect:
DEVICE
RATI
NG
COMPONENT
PROTECTED
LOCATION
1 Circuit
breaker
25
Rear vacuum motor
Right of
steering column
2 Circuit
breaker
25
Optional front vacuum
motor
Right of
steering column
3 Circuit
breaker
35
Left side scrub brush
Right of
steering column
4 Circuit
Breaker
35
Right side scrub brush
Right of
steering column
6 Circuit
breaker
5
Squeegee actuator
Right of
steering column
7 Circuit
breaker
5
Brush actuator
Right of
steering column
8 Circuit
breaker
10
Ignition, horn, battery
and hour meter
Right of
steering column
Fuse
8a
Touch pad
Right of
steering column
Fuse
200
Drive System
Electrical panel
