Windsor EM-21A, Инструкция по эксплуатации

Страница: 8 / 26

1 15V
Page 8 of 26
When installing new belts
use
following sequence:
24
NOTE Drive motor and pump are
to
allow for belt
Loosen screws holding pump and
motor
A. Install pump drive belt then rotary
union drive belt Slide motor rear
ward until rotary union drive belt
is tight Tighten motor screws
Slide pump forward until drive belt
is tight Tighten pump screws
PUMP
REMOVAL
1.
machine power cord from
2.
To access auxiliary pump, refer
to
electrical source
‘Tank Removal’ instructions
25
3. Disconnect pump leads terminal
block
4. at
branch
tee
(special
push lock hosebarbs allow hose
to
swivel without damage hose during
removal and assembly)
5. Remove
4
screws holding pump
to
frame and lift out pump
6. Remove outlet hose with hosebarb from
pump head
7. Lay pump on bench and refer
to
auxiliary pump breakdown for replace-
ment parts
8.
Reinstall pump in reverse of Step
1
through
6
above
MOTOR REMOVAL
ROTARY
UNION DRIVE
MOTOR)
1.
Disconnect machine power cord
from electrical source
2. To access dnve motor, refer
to
“Tank Removal” instructions
3. motor leads from ter-
minal block and (Refer
to Photo 25
4. Lift front of machine and tilt back-
wards until machine rests
on
control
handle
(Photo 12)
5. Remove belt access cover
(Photo
6. Loosen
4
screws holding motor
to
frame, slide motor forward and
re-
move belts from motor pulleys
28
7. Remove screws holding motor and
6. Inspect motor, repair or replace as
motor out
required
9. When installing motor pulley,
for spacing
(1
inches
from face of motor
to inside edge
of outer flange on pulley).
10. Install motor in reverse of above
steps
11. If
required, refer
to “Belt
Replace-
”
FRONT
AXLE
AND WHEEL
ASSEMBLY REMOVAL
1. Disconnect machine power cord
from electrical source
2. Remove tanks, refer to “Tank Re-
moval” instructions
3. Remove belt access cover (Photo
12).
4. Remove bottom splash guard
31
Remove dnve cham from sprocket
NOTE:
Chain has master link for
easy removal