
Shower control
WimTec OCEAN P6 with thermal disinfection
27
EN
PROOF P6 with thermal disinfection
Assembly
Art. no. 121 032
7.
Feed the included connection cable into the installation
space and connect it to the power supply (art. no. 117 899
for 1 control or art. no. 113 792 for up to 5 controls).
Attention: The power must be switched off, and the po-
wer supply must not be installed in the shower panel or
the protected zone!
8.
Remove the electronics module from the Velcro fastener and
turn it around to configure programs and functions.
9.
Configure the desired functions using the electronics module
(see p. 23).
10.
Hook the shower panel into the front bracket strap.
11.
Connect the flexible tubes and included valves to the water
inlets.
9
11
10
7
8
ATTENTION!
Perform the following steps
in the order indicated!
!
ATTENTION!
Observe the wiring diagram
on page 6 and the polarity
(green = + / yellow = -)!
!