10
Controls
Control Panel – FK350
The
Control Panel
(Figure 4) is located on the
front the cabinet stand and consists of the
Power
and
High/Stop/Low
switches, described
below.
Power Switch
– The
Power
switch has two
positions,
Off
and
On.
High/Stop/Low Switch
– This switch controls
the blade speed. To operate the saw, the power
switch must set to on,
High
or
Low
must be
selected
and
the
Run Trigger
depressed.
Figure 4
Trigger Handle – FK350
To operate, the
Power
switch must be set to
on
a
Hi
or
Low
speed selection made, and the
trigger handle, depressed.
Figure 5
Control Panel – FK350-SX
Emergency
– Emergency Stop: This turns off
the controls, and the machine. When used, it
requires that “Control On” button be pushed.
Vise
–
Open/Close (Manual mode
Mode selection
– Select Semi-auto, or Manual
mode.
Start
– In manual mode, this starts the saw
blade. In Semi-auto, this starts the cut-cycle.
Head-UP/ Head-Down
– Manual mode only
Feed rate
– sets feed rate of cut cycle
Figure 6
High/Stop/Low Switch
– Refer to Figure 7;
located on the front of the cabinet stand;
controls the blade speed (Figure 7).
Figure 7
Содержание -SX
