© by WilTec Wildanger Technik GmbH
Item 61138
Page 8
05 2021
-1
Line of cut (Fig. 7)
The gap on the blanking rod indicates the line of the cut. The width of the
gap is the same as the width of the cut. Make sure to align the cutting line on the work piece with the
gap.
•
Pre-grease: Coat the cutting line of the workpiece with oil to in-
crease the efficiency and
strengthen the durability. It’s especially
important when cutting aluminium.
•
Method of die cut (Fig. 8): Hold the electric tool to make the die
cut chip at right angles (90°) to the workpiece being cut and push
the machine slightly according to the cut direction.
•
Cut-outs (Fig. 9): Cut-outs can be done by first opening a round
hole of at least 21 mm in diameter which the cutting head can be
inserted into.
Cutting corrugated or trapezoidal metal sheets
When cutting corrugated or trapezoidal metal sheets, make the punch
face the cut direction whether to cut it at an angle or at right angles. When
operating the direction of holding the tool must run parallel to the corru-
gating direction. Make sure that the die cutting chip works at right angles
(90°) to the workpiece being cut (Fig. 10 and 11).
Maintenance and daily care
Caution:
Always be sure that the tool is switched off and unplugged be-
fore attempting to perform inspection or maintenance.
•
The tool and its air vents have to be kept clean. Regularly clean
the tool’s air vents or when the vents start to become dirty.
•
Check all the screws periodically if they are loose and tighten
them if so.
•
Check the cable insulation regularly.
Replacing carbon brushes
•
Remove and check the carbon brushes regularly. Replace when
the tool produces obvious sparks or the brushes are strongly worn
down.
•
Both carbon brushes should be replaced at the same time. Only
use the original brushes provided.
•
Use a screwdriver to remove the brush holder caps. Take out the
worn carbon brushes, insert the new ones and secure the brush
holder caps.
Caution:
Be sure to re-install the knob after inserting new carbon brush.
•
After replacing brushes, plug in the tool and break in brushes by running the tool without for
about 10 min. Then check the tool while running, when releasing the switch trigger. If the tool is
not working well, ask your authorised service centre for repair.
•
To maintain product safety and reliability, repairs or any other maintenance should be performed
by and an authorised service partner, always using original replacement parts.