WilTec 61138, Руководство по эксплуатации, Страница: 7 / 11

© by WilTec Wildanger Technik GmbH Item 61138 Page 7
http://www.WilTec.de
http://www.aoyue.eu 05 2021 -1
http://www.teichtip.de
Changing the position (Fig. 5)
Warning: Before changing the position of the die cut, make sure that the
switch of the tool is turned off and the power plug is pulled out.
The position of the die cut can be changed within 360° according to the
following steps:
1. Loosen the cap nut with the attached wrench.
2. Pull the blanking rod slightly and rotate it to a desired position.
3. Tighten the cap nut to fix the blanking rod at the desired position.
4. There are 4 fixed positions separately at 90° and 0° on the right such as 90° and 180° on the
left. Locate it according to the following steps:
•
Loosen the cap nut with the attached wrench.
•
Pull the die cutting chip rod slightly and then slightly press it while turning the it into the
desired position. The rod will be chucked at the desired position in one the four above fixed
positions.
•
Rotate the die cutting chip rod slightly to make sure that the rod is chucked at a fixed posi-
tion.
•
Tighten the cap nut and fix the rod.
Switch on and off (Fig. 6)
Caution: Before plugging the tool into a socket, check whether the switch
works properly. Press down the trigger to see whether the back switch is
turned into the off position.
To switch on: Push the back of the switch forward and press the front of
the switch down to lock it.
To switch off: Press the back of the switch down to turn it off.
Thickness gauge (Fig. 7)
The recess of the blanking rod is considered as a measuring scale which
indicates the allowable thickness of the die cut.