WilTec 61138, Руководство по эксплуатации, Страница: 6 / 11

© by WilTec Wildanger Technik GmbH Item 61138 Page 6
http://www.WilTec.de
http://www.aoyue.eu 05 2021 -1
http://www.teichtip.de
Functional description
Assembly
•
Installing and removing the punch and die:
Caution: Always be sure that the tool is switched
off and unplugged before removing or installing
the punch and die.
•
Make sure to replace the punching needle and
the punching die set. When disassembling them,
loosen the cap nut with the wrench and disas-
semble the rod out of the tool. Then loosen the
nut fastening the punching die with a hex wrench.
Disassemble the punching die out of the rod and
then loosen the screw rod fastening the punching
needle with a hex wrench. Pull the punching nee-
dle out of the rod (Fig. 1 and 2).
•
When assembling the punching needle and the
punching die, insert the punching needle into the
clamp to make the hole face the fastening screw
rod and then tighten it. Put the punching die into
the blanking rod and tighten the fix screw cap. Fi-
nally put the blanking rod into the tool to make the
punching needle insert the tool through the hole
in it and tighten the screw cap to fix the blanking
rod and the tool. Grease it after finishing the re-
placement of the punching needle and the
punching die set. (Fig. 3 and 4).