5
6
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Hours: 7 am to 6 pm MST.
Cell Tower
Drip hole on bottom
Installing Lightning Protection
(sold separately)
Outside Antenna Installation
The Outside Antenna should be mounted as shown in the
illustration above . The mounting bracket, included with Outside
Antenna, is adjustable and will accommodate pipe diameters
from 1 .25” to 2” (pipe sold separately Part# 901117) . Mount the
antenna so that there is at least 3 feet of clearance in all directions
around it . Position the antenna so that it has an unobstructed line
of sight to the cell tower’s strongest signal . Make sure the Outside
Antenna is not pointing across your own roof or at the Inside
Antenna as this will cause the oscillation protection circuitry to
shut down the Signal Booster .
Warning
Lightning protection is recommended for all installations (sold
separately) (Part #859902) . Take extreme care to ensure that neither
you nor the antenna comes near any electric power lines .
Install the Lightning Surge
Protector (LSP) close to
the Signal Booster . Attach
the cable from the Outside
Antenna to the surge
protector, using a short
length of low loss cable;
attach one end to the LSP
and the other to the Outside
Antenna connector on the
Signal Booster . Attach a
ground wire (not included)
to the LSP . LSP may be
purchased at
www.WilsonElectronics.com
or 800-204-4104 .
To the Outside Antenna
Ground Wire
(not included)
Lightning Surge
Protector
Signal Booster
