WILSON AUDIO Activ XO, Руководство по установке и эксплуатации

Страница: 11 / 44

s
e C T i o n
1 . 2— C
o n n e C T i n g T h e
a
C T i v
X
o
—M
u s i C
s
y s T e M
11
W i l s o n A u d i o S p e c i a l t i e s
connectors pass the high pass section of the signal to your
main amplifier for your loudspeakers. Connect the High Pass
Output, left and right, of the ActivXo to the inputs of your
power amplifier. Use the XLR inputs for balanced cables or the
RCA inputs for single-ended cables.
4. On the ActivXo front panel in the High Pass section, locate the
switch labeled “BAL,” and “UNBAL.” Select “BAL” for use with bal-
anced cables, or “UNBAL” for use with single-ended cables.
5. Locate the switch on the front panel labeled “HP IN,” “REM,” and
“HP OUT”. This switch defeats or alternatively engages the high
pass filter. Turn the switch to the HP IN position.
6. Locate the switch on the front panel labeled “HP 6 dB” and “HP
12 dB”. This switch changes the slope of the high pass filter to
either 6 decibels per octave or 12 decibels per octave. The po-
sition of this switch will be set in its final position in the final
tuning stages of the ActivXo. For now, set the switch to the 6
dB per octave position.
7. Proceed to Section 2, “Front Panel Setup and Final Tuning,” to
continue the setup of your unit.
Note: Before proceeding with the Front Panel setup and configuration,
please connect your system as outlined in Section 2, which contains valu-
able information needed before proceeding further.