WILSON AUDIO Activ XO, Руководство по установке и эксплуатации

Страница: 10 / 44

10
ActivXo I n stal l ation and Car e G u ide
A u t h e n t i c E x c e l l e n c e ™
6. On the front panel in the High Pass Section, find the switch
label “HP IN,” “REM,” and “HP OUT”. Select “HP OUT.” When “HP
OUT” is selected, the signal at the “HIGH PASS OUT” connectors
is full range.
7. On the front panel Low Pass section, locate the switch labeled
“LP IN,” “REM,” and “LP OUT”. Select “LP IN.”
8. Proceed to Section 2, “Front Panel Setup and Final Tuning,” to
continue the setup of your unit.
Utilizing the High Pass Filter
The ActivXo employs a high quality high pass filter as a part of its cross-
over design. The High Pass Filter can be used to filter bass from the main loud-
speakers. This can be desirable in systems where the main loudspeakers have
limited bass dynamics or if the main amplifier is low power. Use the following
steps to utilize the high pass filter:
1. Make sure the ActivXo power is off during the connecting pro-
cess.
2. On the rear of the unit, locate the Line Level inputs of the
ActivXo. Connect the preamplifier output, left and right, to the
Line Level input of the ActivXo. Use the XLR inputs for bal-
anced cables or the RCA inputs for single–ended cables.
3. Locate the High Pass Output on the rear of the ActivXo. These