WILSON AUDIO Activ XO, Руководство по установке и эксплуатации

Страница: 8 / 44

8
ActivXo I n stal l ation and Car e G u ide
A u t h e n t i c E x c e l l e n c e ™
balanced connector for each output.
Setup for a single, mono sub:
1. If you are using a single subwoofer, select Mono. In Mono,
either the left or the right channel outputs can be used for a
single subwoofer, as they each output the same signal. If you
are using one subwoofer, connect the amplifier driving the
subwoofer to the ActivXo’s “LOW PASS OUT” via either output.
2. On the front panel in the Low Pass section, choose either the
balanced cable or single–ended (labeled “UNBAL”) output to
match the input configuration of the amplifier.
3. Select “Mono” on the Mono/Stereo switch on the rear panel.
Setup for two, stereo subs:
4. If you are using two subwoofers with separate amplifiers, con-
nect the subwoofers to the Left and Right outputs, and select
Stereo.
Bypassing the High Pass Filter
In systems where the main speakers are full-range, the subwoofer used
with the ActivXo can be configured more successfully without the use of the
High Pass filter. Bass roll-off occurs naturally in your listening room. This effect
acts like a 6 dB per octave low pass filter and rolls off the bass from your main