Wilo Yonos GIGA2.0-D, Инструкция по установке и эксплуатации

Страница: 144 / 424

en Installation of CIF module
144 WILO SE 2022-05
Fig. 28: Electronic module
The graphic display can be turned in 90° steps. To do this, open the upper part of the
electronic module using a screwdriver.
The graphic display is fixed in position by two snap-in hooks.
1. Carefully open the snap-in hooks with a tool (e.g. screwdriver).
2. Turn the graphic display to the desired position.
3. Fix the graphic display with the snap-in hooks.
4. Fit the upper part of the module again. Observe the screw tightening torques on
the electronic module.
Component Fig./Item screw
(nut) Thread Tightening
torque
[Nm] ±10 %
(unless other-
wise stated) Installa-
tion in-
formation
Electronic module
upper part Fig. 28, Item 1
Fig. I, Item 2
M5 4.5
Threaded cable
gland union nut Fig. 19, Item 1 M25 11 *
Threaded cable
gland Fig. 19, Item 1 M25x1.5 8 *
Threaded cable
gland union nut Fig. 19, Item 6 M20x1.5 6 *
Threaded cable
gland Fig. 19, Item 6 M20x1.5 5
Power terminals and
control terminals Fig. 20, 21 Pusher Slot 0.6x3.5 **
Earthing screw Fig. 20, Item 5 M5 4.5
CIF module Fig. 28, Item 4 PT 30x10 0.9
Wilo-Connectivity
Interface cover Fig. 1, Item 8 M3x10 0.6
Table 14: Tightening torques for electronic module
* Tighten when installing the cables.
** Press with screwdriver to plug and unplug the cable.
8 Installation of CIF module
DANGER
Risk of fatal electrical shock!
Immediate risk of fatal injury if live components are touched!
• Check whether all connections are voltage-free!
CIF modules (accessories) are used for communication between pumps and building
management systems. CIF modules are attached in the electronic module (Fig. 28,
Item 4).
ƒ
For twin-head pumps, only the main pump must be equipped with a CIF module.
ƒ
For pumps in Y-pipe applications in which the electronic modules are connected to
each other through the Wilo Net, only the main pump also requires a CIF module.
NOTICE
When using CIF module Ethernet, the use of the accessory “Connection M12 RJ45
CIF-Ethernet” is recommended.
Required for easy disconnection of the data cable connection via the SPEEDCON
socket outside of the electronic module when maintenance of the pump is required.