Wilo Atmos TERA SCH 150-230, Инструкция по установке и эксплуатации

Страница: 84 / 100

zh-CHS Maintenance/repair
84 WILO SE 2020-10
9.6 Examination of internal
components
9.6.1 Check of wear rings
Check both wear rings (25) for uneven wear.
ƒ
Measure the bore of the wear ring (25) at intervals around the circumference with an
inside micrometre.
ƒ
Measure the impeller neck diameter at intervals around the circumference with an
outside micrometre. The comparison of both measurements indicates the amount of
diametrical clearance between wear ring and the impeller neck.
Indications for wear ring replacement and restoration of the original clearance:
ƒ
The clearance is 150 % or more of the original design clearance
ƒ
Further deterioration of the hydraulic performance cannot be tolerated in the next
operating period
If one of the indicators is true, replace the wear rings. The clearance between impeller
neck and wear ring must be restored to the original design value. This is done by
installing wear rings with a small bore, bored out to suit the diameter of the impeller.
9.6.2 Check of sleeves
Examine the sleeves to see if they are grooved or worn. If there are grooves or wear,
replace the part.
9.6.3 Check of impeller
Examine the impeller
ƒ
For damage
ƒ
For corrosive /erosion pitting
ƒ
For Cavitations pitting
ƒ
for Bent or cracked vanes
ƒ
For inlet and outlet vane end wear
If damage is extensive, impeller replacement recommended. Before any decision on
repair work, ask Wilo for further information.
Check wear around the impeller neck as described in chapter "Check of wear rings".
9.6.4 Check of shaft & keys
Examine the shaft
ƒ
For the trueness
ƒ
for mechanical damage and corrosion
If the shaft is not true within 0.1 mm TIR (Total Indicated Reading), replacement or
repair is recommended. Before any decision on repair work, ask Wilo for further
information.
Examine the shaft keys and keyways for damage and wear. Remove and replace
damaged or worn out keys.
9.6.5 Check of bearings
The ball bearings fitted on the Atmos TERA-SCH series are greased for life. No
maintenance is required. Check that bearing rotates freely and smoothly, verify that the
outer ring presents no abrasions or discolouration. If there is any doubt regarding the
serviceability of the bearing, replacement is recommended.
Designation Size
SCH 150-230
6306 ZZ C3
SCH 150-555
6312 ZZ C3
SCH 200-320
6308 ZZ C3
SCH 200-500
6312 ZZ C3
SCH 250-360 6308 ZZ C3
SCH 250-380
6312 ZZ C3
SCH 250-470
6312 ZZ C3
SCH 300-430
6312 ZZ C3
SCH 350-500
6312 ZZ C3
SCH 400-580
6316 ZZ C3
SCH 400-490
6313 ZZ C3