®
5
of the unit. On power up, “Williams Sound T800” will appear
briefly while the system initializes. The system will then dis-
play the current operating “CHANNEL” (1-16).
• S
tep
4: S
elect
the
F
requency
The T800 operates on the 863-864 MHz bandwidth with six-
teen selectable preset channels. Channels 1-3 are standard and
coincide with channels 1-3 on the R863 (optional) receiver:
CH 1
= 863.250 MHz,
CH 2
= 863.750 MHz,
CH 3
= 864.750 MHz
Non-standard operating channels (4-16) available are:
CH 4
= 863.050 MHz,
CH 5
= 863.400 MHz,
CH 6
= 863.550 MHz
CH 7
= 864.000 MHz,
CH 8
= 864.150 MHz,
CH 9
= 864.300 MHz
CH 10
= 864.450 MHz,
CH 11
= 864.600 MHz,
CH 12
= 864.950 MHz
CH 13
= 863.150 MHz,
CH 14
= 863.650 MHz,
CH 15
= 863.900 MHz,
CH 16
= 864.850 MHz
The T800 is set at the factory to Channel 1 (863.250 MHz).
To change the channel, press and hold the “Set” button for 3
seconds (cursor will flash), then press the “+” Up or “-” Down
button until the desired channel (1-16) is displayed. No further
action is required, the selection will be saved into memory
after 3 seconds.
To view the current operating
frequency
(i.e. “863.250 MHz”)
on the T800, press the “MENU” button once. To change the
operating frequency, press and hold the “Set” button for 3
seconds (cursor will flash), then press the “+” Up or “-” Down
button until the desired frequency is displayed. The selection
will be saved into memory after 3 seconds.
• S
tep
5: c
onnect
the
a
udio
S
ource
On the back of the T800, two audio input jacks are available:
an RCA-type jack for line-level, unbalanced audio sources;
and a combo XLR (3-pin) and 1/4” TRS jack for connecting
unbalanced/balanced audio sources. Connect the desired audio
source to the T800 transmitter and proceed to Step 6.
