Will Burt 711990491, Руководство по эксплуатации, Страница: 91 / 114

S
TILETTO
AL O
PERATING
I
NSTRUCTIONS
TP-5418901-F Original Instructions 5-3
August 2020
5.2 Maintenance Equipment
Table 5-1 lists recommended equipment for maintenance.
Table 5-1 Equipment Recommended for Maintenance
Recommended Equipment*
Personal Protective
Safety Glasses Work Gloves Nitrile or Vinyl Gloves
Hearing Protection Hard Hat or Helmet Safety Shoes
Hand Tools
Paint Brushes Screwdrivers Torque Wrench
Wire Brush Wrenches
Equipment
Grease Gun Hoist Sling
Expendables
Denatured Alcohol or Other
Solvent Drive Screw Lubricant
(P/N: 4288601) Non-Abrasive Cleaners
(Soap and Water)
Rags (Soft, Clean, and Dry) Touchup Paint
* Note:
•
Depending on the local, regional, and national standards and codes of practice, and the environment,
additional personal protective equipment may be necessary.
•
When disposing of any disposables or components, do so according to any applicable local, regional, and
national standards and codes of practice.
5.3 Spare Parts
To order spare or replacement parts, always refer to the mast model number and serial number.
The model number, serial number, and additional information is engraved on the mast
Identification Plate (Section 1.7.1.11).
Throughout this manual, “P/N” followed by a number
represent the part number for that component. To order spare parts, or for the part numbers for
additional components, contact The Will-Burt Company.
5.4 Preventative Maintenance Checks and Services (PMCS)
This section describes the systematic care, inspection, and servicing of equipment to keep it in
good condition and to prevent breakdowns. If the Mast System does not perform as required,
see Section 8. If anything looks wrong and cannot be diagnosed and/or fixed, the Mast System
should be taken to the next higher level maintenance facility. The Will-Burt Company
recommends creating and maintaining a maintenance log for each Mast System.