Wildfire F-131 2 Series, Инструкция пользователя

Страница: 18 / 44

18
3.4.2 Use a smoke pellet prior to the appliance installaon to ensure the viability of
the flue and check that the smoke can be seen being emiMed from the terminal /
chimney pot outside. There must be no leakage of smoke through the structure of
the chimney/flue during or aer the smoke pellet test and it is important to check
inside upstairs rooms adjacent to the chimney / flue. Check the chimney pot /
terminal and general condion of the brickwork or masonry. If the chimney or flue is
in poor condion or if there is no up-draught do not proceed with the installaon. If
there is a history of down-draught condions with the chimney / flue, the installaon
of a tested and cerficated flue terminal or cowl suitable for the relevant flue type
should be considered.
Appliance
Dimensions
3.4.3 The following drawing shows the appliance dimensions. Note: if calculang
chamber sizes and minimum clearances regarding side clearances shown on the next
page, appliance width should be taken as 436mm
Check
The Flue
Hearth
3.4.1 This appliance must stand on a non combusble hearth with a minimum
thickness of 12mm. The hearth must protrude a minimum of 50mm to the le and to
right of the appliance and at least 150mm in front of the appliance.
Building regulaons do allow for a minimum of 50mm protrusion for each of these
dimensions, however we recommend the values stated above to provide a
reasonable physical boundary from the appliance due to high temperatures of
working surfaces, such as the glass panel.
INSTALLATION INSTRUCTIONS