Wilbar Optimum Pool Round 95-0770, Общее руководство по инструкции

Страница: 16 / 51

OPTIMUM ROUND ABOVE / IN-GROUND POOL
Section 1
Section 2
Step 4
– Anchor Plate Installation
14
4.1 Ensure panels are centered and fully inserted into the
Anchor Plates.
Drill two 7/16" holes through the pool panels at each Anchor Plate
locations using the Anchor Plate holes as a drill guide. Secure
panels with 3/8” x 2-1/2” bolts (#99-0137) and nuts (#99-0134).
4.2 IMPORTANT!
Confirm roundness of the pool by measuring the diameter
across the pool at each panel joint. All diameters should be
identical. Adjust, as necessary. If this step is not completed,
the pool may not be perfectly round, which could lead to
problems later, and may void your warranty.
4.3 IN-GROUND ONLY : If the pool installation is greater than
24” below grade, the included rebar must be used with an 8” high
x 12” wide concrete collar around the perimeter of the pool. Insert
the rebar halfway into the ground through the Anchor Plate holes
before pouring the concrete collar.
If the pool is installed less than 24” below grade, skip this step.
4.3
4.1
ABOVE GROUND / IN-GROUND