WIKA CTB9100-165, Руководство по эксплуатации

Страница: 23 / 80

GB
Temperature Dry Well Calibrators/Micro Calibration Baths
CTD9100/CTB9100
11263911 04/2007 GB/D
WIKA Operating Instructions Temperature Dry Well Calibrators/Micro Calibration Baths
SLoF
flashes on the upper
PV
display.
The respective currently set cooling gradient
appears on the lower SV display.
Press the
5
key to increase the cooling gradient

Fig. 4: Cooling gradient entry
Fig. 44: Display of the cooling gradient input
SLoF .
Press the

key to decrease the cooling
gradient SLoF .
Press the
5
and

key to raise and
lower the value by 0.1 respectively.
If the keys are held pressed for at
least one second, the value increases
or decreases quickly and after two
seconds even more quickly; this means
the desired value can be reached
rapidly.
Press the
P
key to confirm the set
cooling gradient
SLoF
.
The display returns to the parameter
level and other parameters can be set.
If no key is pressed for approx. 15
seconds, the device automatically
returns to a previous level up to the
calibration mode.
After carrying out the settings, the
calibrator/micro calibration bath uses
the new values only when modifying
the set temperature or switching the
calibrator/micro calibration bath off and
on again.
6..7. Setting the duration time

The duration time “dur.t“ is active if the set
temperature SP1 has been achieved. Subsequently,
the calibrator/micro calibration bath automatically
switches to set temperature SP2.
The setting range extends from 99:59 [hh:min] to
00:00 [hh:min].
The function is deactivated if dur.t =
InF (In no Function) has been set.
You are in the parameter level (as described in
section 5.3.7 ).
’rEG appears on the upper PV display.
SLor flashes on the lower SV display.
Use the
5
or

key to select the parameter dur.t .
Fig. 45: Parameters for heating gradient SLor
Fig. 46: Parameters for the duration time dur.t
Fig. 47: Duration time entry
’rEG
appears on the upper
PV
display.
dur.t
flashes on the lower
SV
display.
Press the
P
key.

dur.t flashes on the upper PV display.
The respective currently set duration time
appears on the lower SV display.
Press the
5
key to increase the duration time
