WIENER, Plein & Baus GmbH
18
www.wiener-d.com
2) Define the pre-trigger range (example 20 = 0.2µs) to match the required pre and post
trigger time range.
3) Click on Set to store the conditions
4) Click on Run to start the bus analyzer, the red AQ LED will light up (field “Run” will
change to “Halt”)
5) In case any VME access will match the defined address range the
AQ
LED will go
off and the blue
F4
LED will flash indicating that waveform data for read-out are
available
6) Click on “Read Waves”
7) Select the lines to be shown on the waveform plot. This will open a new window
“Waveforms” showing the selected bus line waveforms. With the mouse cursor it is
possible to zoom (curser in “cross-mode”) in by selecting a range between time lines
or zoom out and also measure time intervals between the time cursor bars.
8) To change the display it is possible to add or remove bus lines by selecting or
unselecting those in the “Select Waves to Display” fields.
