WIELANDER+SCHILL VAS 821 003, Руководство по эксплуатации

Страница: 17 / 32

Operation Manual MIG-MAG Alu welding - brazing / VAS 821 003
©
Wieländer + Schill
Page 17
4.2.5.1 List of MENU parameters:
Display
Name
Description Min. Max. Step Unit
MIG
Pulse
MIG
Double
Pulse
MIG MMA TIG
GPr
Gas pre-flow time 0,0 10,0 0,1 sec
X X X - -
GPo
Gas post-flow time 0,0 10,0 0,1 sec
X X X - -
hSL
Hot-start level 100 199 1 %
X X X X -
cFL
Crater-fill level 1 100 1 %
X X X - -
hSt
Hot-start slope time 0,0 10,0 0,1 sec
X X X X -
cFt
Crater-fill slope time 0,0 10,0 0,1 sec
X X X - -
Act
Active time for interval weld. 0,0 10,0 0,1 sec
X X - - -
PAU
Pause time for interval weld. 0,0 10,0 0,1 sec
X X - - -
These parameters are reset to factory settings
when changing the material thickness selection.
Global menu parameters
Parameters that are independent of the selected filler material, wire diameter and base
material thickness are referred to as general parameters. All these parameters can be set by
the user in the menu. They remain saved and unchanged as long as the user does not change
the setting. The parameter group includes:
1. Gas pre-flow time
2. Gas post-flow time
3. Hot-start level – Hot start level in percent, based on the preselected
Welding current. Can only be> 100%.
4. Crater-fill level – Crater fill level in percent, relative to the selected one
Welding current. Can only be <100%
5. Hot-start slope time – a time which is needed to slope from hot start level to the
welding level. In seconds.
6. Crater-fill slope time – a time which is needed to slope from welding level to the crater
fill level. In seconds.
7. Active time – parameter for automatic interval welding, which defines an
active welding time in seconds
8. Pause time
– parameter for automatic interval welding, which defines an
inactive time, when arc is off in seconds. If it is set to 0, interval
welding is disabled.
Synergetic controlled parameters