Operation Manual
InvertaPuls IP4-3
Page 19
JOB
JOB
4.4
JOB Mode
The JOB mode allows you to store up to 100 individual parameter settings in addition to the
preset programs.
Change from synergic mode to JOB mode
JOB
is
made by short press of the JOB button . After entered the Job
mode, number of actual job is shown in the Material thickness / JOB
window. There are 100 jobs available: J00 – J99. By Turning main
encoder can be chosen required job number.
While in JOB mode, there are no set up and adjustments available
except the JOB number and welding mode. If adjustment is required,
JOB editing must be activated – see following section
To quit from JOB mode press JOB button
JOB
again.
4.4.1
Editing / saving the JOB
While working in synergic mode
, by long pressing the JOB button
actual set
up
can be stored. After long pressing of JOB button, number of job starts to flash. This number
can be changed by encoder rotation, after desired job number is set by pressing the
encoder button actual set up is saved under this job number.
To edit actual job, set job number to change, by long pressing the JOB button
the
material thickness start to flesh and any change of any parameter can be made. After
changes are made, by short press of encoder button will be stored.
4.5 Selecting the active feeder
Active feed unit selection is indicated by LED indicator above the corresponding euro torch
connector. To switch the idle feed unit on, must be just pressed the trigger button on the
corresponding torch. By pressing the trigger button on the not active feed unit, it will switch
to active state with automatic up-loading of all appropriate settings on the front panel. After
releasing the torch button and pressing it again the welding process will start.
4.6 Parameters setup for different feed units
There can be made specific setup for each feed unit. All settings made on the front panel
are belonging to the active feed unit and will be stored in internal memory in case of
switching the feed unit to idle state or switching the machine off. Always if some setup
should be done, the feed unit must be set as active.
