5
Mounting of flat cable inside switchgear cabinet
Wieland Electric GmbH | BA000369 (Rev. B) | 02/2016
23
5.2
Feeding through distributor module
A round conductor is routed into the field from the switchgear cabinet. This conductor is connected to
the flat cable through the distributor module (FCS 4 7 SA SA SW, 75.010.0053.1).
Advantages:
• Central feed of up to 32 A possible
• Simultaneous branching of up to 3 cable connections
Disadvantages:
• Comparatively high assembly efforts
The following conductor cross-sections can be connected:
• 0.5 - 4 mm² single-wire or with wire end ferrule • 0.5 - 6 mm² single-wire
5.3
Feeding through 7-pin connection module
A round conductor is routed into the field from the switchgear cabinet. This conductor is connected to
the flat cable through the 7-pin connection module (FCS 4 7 SI FK, 75.018.0051.2).
Advantages:
• Central feed of up to 25 A possible (derating)
• Uninterrupted feed through insulation-piercing termination - fast and secure
Disadvantages:
• Maximum feeding current of 25 A
• The connection module has branching points for round conductor fittings on all sides.
• These have to be ordered as extra accessories depending on the application.
NOTE
Feeding through the connection module is the most cost-effective solution for the power feed (requirement for this application:
the supplied current must be sufficient for the intended application of the power bus segment).
