3
podis CON flat cable
12
Wieland Electric GmbH | BA000369 (Rev. B) | 02/2016
Mounting and routing of flat cables with cable clamps
The cable clamps (see ordering instructions) are fitted to solid subsurfaces by means of screw fitting. The
flat cable is suspended from the mounted cable clamps (see drawing, variant A).
To secure the flat cable against being pulled out, mount two cable clamps immediately next to one an-
other so that they are put up on the opposing sides of the flat cable (see drawing, variant B).
This type of mounting can also be applied for the vertical routing of flat cables. However, offset cable
clamps with alternating stops are also sufficient in this case (see drawing, variant C).
3.3
Cutting flat cables to length
In order to cut the
podis
®
CON flat cables to length, the cables are separated by a single cut with a pair of
cable shears.
Required tools:
Figure: Cable shears (95.300.0300.0)
Cut the flat cable to length as desired using the cable shears
(95.300.0300.0). Ensure a clean, square cut. Avoid fraying of the cop-
per cores.
Figure: Cutting flat cable to length
