Flex Cut RMR 230 H
3 Safety notes
05 | 2021
846 99 01
–
003
21
Maintenance and repair work
Improper servicing and repair work jeopardises operational reliability. This can then lead to a risk of serious or even fatal
injuries.
➢
Only perform the work described in these operating instructions.
➢
Prior to performing any work, shut down and secure the machine, see Section
3.7.1 "Shutting down and securing the machine".
➢
Have all other servicing and repair work performed exclusively by a qualified specialist workshop.
Raised machine or machine parts
The raised machine or raised machine parts can descend or tip over unintentionally. This can then lead to a risk of serious
or even fatal injuries.
➢
Do not stand or remain below the raised machine or raised machine parts that do not have proper supports, see
Section 3.7.1 "Shutting down and securing the machine".
➢
Prior to performing any work below a raised machine or raised machine parts, secure the respective machine or
machine parts and prevent them from descending using a rigid safety prop or hydraulic locking device and
suitable supports.
Hazard due to welding work
Welding should only be carried out by persons with a relevant
qualifying certificate i.a.w. EN287.
Improper welding work jeopardises the operational reliability of
the machine. This can then lead to a risk of serious or even fatal
injuries.
➢
Never weld any of the following parts:
•
Gearboxes
•
Components of the hydraulic system
•
Chassis or load bearing assemblies
➢
Prior to performing welding work on the machine, shut
down the machine securely.
➢
Attach the earth of the welding device near to the
welding point.
➢
Avoid generation of toxic vapour and dust.
Hazardous fumes can be produced when paint is
heated by welding, soldering, or using a torch.
➢
Do all work outside or in a well ventilated area.
➢
Dispose of paint and solvent properly.
➢
Remove paint before welding or heating:
•
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
•
If you use solvent or paint stripper with soap and
water before welding. Remove solvent or paint
stripper containers and other flammable material from
the area. Allow fumes to disperse at least 15 minutes
before welding or heating.
