Flex Cut RMR 230 H
8 Operation
05 | 2021
846 99 01
–
003
37
8
Operation
8.1
General information on operation
CAUTION!
Unsecured mower during transport!
➢
Raise the lawn mower during transport to the place of use and secure against inadvertent lowering.
(Block the lifting hydraulics)
8.1.1
Before mowing work
➢
Release the transport lock.
➢
Lower the mower using the front power lift.
➢
After lowering lock the power lift lever in the floating position
–
in this position the mower can adapt to rough
grounds.
➢
Set the engine to full throttle and the turn on the front PTO shaft.
➢
The working speed should be selected according to the operating conditions.
➢
In case of very high or wet grass it is recommended to start with pre-cutting and then to rework with a low blade
position, or to vertically lift the mower on the two front support wheels ba two distance rings (30 mm) before
mowing.
➢
Also, the tractor should be turned around only on the area which has already been worked.
8.1.2
After mowing work
➢
Clean the mower unit.
➢
Maintain the mower unit.
➢
Check blades for damages and a tight seat.
8.2
Mowing high grass
8.2.1
Method 1
➢
Mow grass twice.
➢
Adjust the cutting height of the mower unit such a position that the high grass is cut to the half height.
➢
For the second mowing operation adjust the mower unit to the desired height.
8.2.2
Method 2
➢
At a slow driving speed mow the full width to the desired height,
or
➢
only mow the half width to the desired height.
