Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
10.12.2013 Working
instructions
WIDOS PSM 20
Page 17 of 31
Remove the clamping beams, disassemble each handle and mount it on the opposite side.
Insert the beams back again into the machine; left beam to the right and right beam to the
left.
Fix both rear cylinders and clamping beams using the threaded bolts.
Connect the hydraulic hoses to the cylinder; the blue hose at the top and black one at the
bottom.
Lift the clamping beam at the front and swing the piston rods in
again; the beam must rest on the washer afterwards.
4.3. How to clamp sheets for angle welding
You may weld an angle out of two plastic sheets on the
WIDOS PSM 20
.
The horizontal sheet of 10 - 20 mm is clamped onto the left side (chapter:
4.2).
The vertical sheet, from 5 mm thickness, is clamped onto the right side.
First clamp the right beam (without sheet) tightly onto the right attachment.
Put the vertical sheet onto the interior of the right clamping beam onto the ledge and fix sheet
e.g. with screw clamps.
(The picture shows a machine with manual clamping)
ledge for horizontal sheet
horizontal sheet
vertical sheet
spacer
screw clamp
beam side flushing
