Starting and operating
Chapter 5
Chapter 5
Chapter 5
Chapter 5
16.05.17
Working Instructions WIDOS MAXIPLAST
Page 19 of 41
wide clamping tool
wide clamping tool
fitting clamping tool
(fitting reduction insert, optional)
(optional)
5.2.
5.2.
5.2.
5.2.
Welding process
Welding process
Welding process
Welding process
I n p r i n c i p l e , t h e v a l i d w e l d i n g r e g u l a t i o n s ( I S O / C E N / D V S . . . ) a r e t o b e
I n p r i n c i p l e , t h e v a l i d w e l d i n g r e g u l a t i o n s ( I S O / C E N / D V S . . . ) a r e t o b e
I n p r i n c i p l e , t h e v a l i d w e l d i n g r e g u l a t i o n s ( I S O / C E N / D V S . . . ) a r e t o b e
I n p r i n c i p l e , t h e v a l i d w e l d i n g r e g u l a t i o n s ( I S O / C E N / D V S . . . ) a r e t o b e
o b s e r v e d .
o b s e r v e d .
o b s e r v e d .
o b s e r v e d .
•
Put on safety gloves to protect you from being burned.
•
A stop-watch should be available in order to be able to register the actual times for heating up and
cooling down.
•
A table should be available from which you can read the parameters that are prescribed by the
welding regulation for the pipe diemesion to be welded.
•
The heating elements are to be clean and, above all, free from grease. Therefore they are to be
cleaned with non-fraying paper and detergent (e.g. technically pure alcohol or pipe-cleansing
cloths which can be bought at the WIDOS company) before every welding or if they are dirty.
The anti-adhesive coating of the heating element has to remain undamaged in the working
area.
•
Switch on heating element and set the required welding temperature on the adjustment screw on
the handle.
•
If the control light flashes, the nominal temperature has been reached and is held at a constant
level through a given impulse-break relationship.
•
Screw in reduction inserts according to the outer diameter of the pipes to be welded, if necessary
set the angle.