Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone ++49 (0)7152 / 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
++49 (0)7152 / 9939 - 40
Webside: www.widos.de
email: [email protected]
14.02.2012
Working instructions WIDOS 2500 - 250 adjustable
Page 28 of 48
7. Maintenance / storage / transport
Goal of the chapter is:
•
Keeping the nominal state and the operation capacity of the machine.
•
Efficient planning of the maintenance work and the maintenance tools.
•
Increasing the efficiency by avoiding non planned outage.
7.1. General
•
Replace damaged parts
immediately
, be particularly careful at electrical parts - dirt and
wetness are very good current conductors.
•
Only use original
WIDOS-spare parts
.
Prescribed maintenance and inspection work should be performed in time. The
DVS gives the advice of inspection work after 1 year.
For machines with an especially high usage percentage the testing cycle should
be shortened.
The work should be performed at the WIDOS GmbH company or by an authorized
partner.
7.2. Clamping elements
•
For a long service life clean and grease regularly the threaded spindles and the joint parts
which are used for clamping the pipes.
7.3. Planer
•
Never
lay the planer on its blades.
•
Check the blades of the planer for sharpness, turn them if necessary (grinded on both
sides, max. thickness of the cuttings: 0.2 mm!).
•
Check the stress of the drive chain in the planer and grease it regularly. The cover of the
planer can be screwed off for this purpose.
7.4. Storage
Do not
grease the guide rods when using the machine in order to avoid damages
by adhering dust.
•
Keep the guiding and the gear rod of the basic machine free from dirt and make sure that
they must be covered with a slight oil film if not in use.
•
Store the machine dry.
