13
Chapter 2 - Setting Up the SABRE
TM
Ranger
Note:
This following steps are applicable only if you are using the SABRE™ Ranger (V2 variant) terminal:
Follow these steps to power up the SABRE™ Ranger (V2 variant):
1. Insert the power adapter output connector into the DC power input socket on the Heater power cable.
2. Insert the plug end of the power adapter into an AC outlet.
3. Insert the power adapter output connector into the DC power input socket on the Multi-function cable.
4. Insert the plug end of the power adapter into an AC outlet.
5. Turn on the power to power up the heater and SABRE™ Ranger terminal.
6. Allow 30 minutes for the heater to warm up the SABRE™ Ranger terminal.
7. Check to see if the SABRE™ Ranger terminal is working normally.
8. If the SABRE™ Ranger terminal is not working properly, proceed to power cycle the terminal.
After this process, the SABRE™ Ranger terminal should be working normally.
Heater power cable
DC power
input cable
Powering Up the SABRE
TM
Ranger (V2 Variant)
Multi-Function cable
DC power
input cable
