14
7.
Using the push-fit release/
lock tool, place twin bladed
side on the face of the
connectors and push grey
collars into manifold to
release from supply pipes.
8.
Drill wall and insert wall plug.
The wall plugs supplied may
not be suitable for the type of
wall being fixed to. Ensure
correct type of wall plugs are
used.
9.
Cut away and trim the thinned
section at the top or bottom of
the case to allow electrical
supply cables to run down
rear of case.
10.
Route the mains electrical
cable through the channel
and cable entry in the rear of
the base unit.
Caution!
Ensure inlet pipework is
thoroughly flushed.
11.
Locate base unit onto inlet
supplies and push onto
pipework.
12.
Secure base unit to wall
using fixing screws supplied.
