White Mountain Hearth Dv25IN33L-1, Инструкция по установке и руководство пользователя

Страница: 16 / 28

23015-9-1108 Page 16
BLOWER ACCESSORY INFORMATION
The appliance, when installed must be electrically connected
and grounded in accordance with local codes or, in the absence
of local codes, with the current CSA C22.1 Canadian Electrical
Code.
U.S. Installations, follow local codes and the National Electrical
Code, ANSI/NFpA No. 70.
Should this blower require servicing, the power supply must be
disconnected. For rewiring of any replacement components, re-
fer to Figures 16 and 17 and the parts list on page 25.
BLOWER ACCESSORY
Operation
The fireplace insert is equipped with a factory installed blower accessory
that includes a fan control switch, plus a rheostat (speed control).
The speed control knob is located behind the lower louver at the right
side of the insert.
From a cold start, the temperature activated fan control switch will
normally take 5-10 minutes to heat up and energize the blower.
Once the blower is energized, adjust the blower speed control as desired,
then replace the lower louver.
When the insert is shut off, it may take 30-40 minutes for the heated unit
to dissipate (cool down) enough for the blower to shut off automatically.
Note: The blower shut off times will vary on blower speed and BTU
input level setting control by adjustment of the HI/LO knob located on
the gas valve.
Blower removal instructions
Servicing or removal of the blower system must be performed by a
qualified service person.
If the blower assembly (Item 45, page 24) must be replaced, the following
steps are recommended for removal:
1. Turn off gas and disconnect the electrical supply.
2. Remove the glass door assembly.
3. Remove the log set.
4. Remove the front surround panel assembly by lifting upward and
outward to detach.
5. Remove the 5/16” x 2-1/2” center bolt that retains the Vent Slide
plate assembly.
6. Remove the insert from the fireplace cavity by pulling forward on
the insert, and at the same time, sliding the vent plate rearward until
disengaged.
7. As the insert is moved outward, the gas line may need to be
disconnected at the insert shut off valve. If so, make sure the main
gas line is shut off that supplies gas to the insert.
8. Once the insert is pulled out, the blower assembly can be removed
by locating the (6) screws on the lower back of the insert that retains
the blower base plate.
9. When the screws are removed, gently pull the blower assembly
outward.
10. Disconnect the two ¼” wire terminals from the motor.
11. Remove the (4) screws that retain the blower assembly to the base
plate, and set blower aside.
12. Install the replacement blower, and re-install the insert by reversing
above steps.
Figure 16
Figure 17