White Magic PRO 1900, Руководство пользователя

Страница: 35 / 90

WARNING: Rotating equipment has inherent dangers and demands certain precau-
tions. Caution should be exercised to assure that clothing, hair, and hands are not
caught in equipment. Always shut van off and remove key before checking or adjusting
belts, pulleys, pump or blower unless specifically noted. Do not operate system with the
casing removed. The maintenance and troubleshooting steps listed below require some
general mechanical experience and ability. Therefore maintenance personnel should un-
derstand the separate steps required, given only general instructions such as “align the
pulleys or tighten the belts.”
DAILY
1. Drain recovery tank. Be sure to dispose of waste in accordance with Federal, State
and Local laws and ordinances.
2. Remove and clean the filter bag if equipped with a filter box.
3. Check the system vacuum reading with the hose end in the sealed and unsealed con-
dition. Compare the readings from day to day to assure that the vacuum system is
not clogged nor has any air leaks.
4. Visually check that the blower oil is between the two red lines on the oil level sight
gauge. Adjust as necessary.
5. Check the engine oil with the dipstick and adjust as necessary. Allow the machine
to sit for several minutes after shut down so the oil can drain back into the oil pan
for a proper reading.
6. Check the engine coolant level in the radiator and adjust as necessary.
7. Thoroughly check the entire machine to look for any fluid leaks, i.e.oil, coolant,
fuel, chemical, or water. Repair any leaks if necessary.
8. Check the condition of the drive belts. Replace any worn, cracked or frayed belts.
MAINTENANCE SCHEDULE
30