White Magic PRO 1900, Руководство пользователя

Страница: 46 / 90

Maintenance Instructions for Ford Engine (continued…)
Battery
If there is any corrosion on the cables and terminals, remove it with a wire brush and neutralize
the acid with a solution of baking soda or ammonia with water. After cleaning, flush the top of
the battery with clean water, install the terminal clamps on the battery posts, and coat the parts
with grease to retard further corrosion.
Fluid Level (Non-Maintenance Free Battery)
Because the battery is the “heart” of your unit’s electrical system, periodic checks are necessary
to keep it functioning properly. Keep the battery level in each cell up to the level indicator.
Governor
Oil Level
Clean the body of the governor in the area of the fill plug.
Check the oil level by slowly removing the oil level plug. If oil drips out, the oil level is full. If
oil does not drip out, slowly add engine oil into the fill hole. As soon as it begins to drip out of
the hole, insert the plug.
Adjustment
Before making any governor adjustments, check the governor drive belt tension with a belt ten-
sion gauge. Set the belt to the tension listed in the Specification Section. (Replace the belt if
any damage is visible eg., cracks, or shipping damage, ect.)
The first adjustment is the governor-to-carburetor control rod adjustment. With the control rod
connected, manually remove the governor throttle lever to the maximum open throttle position.
Check that carburetor throttle shaft lever is set from 1/32 to 1/16 of an inch from its maximum
open position stop. If necessary, adjust length of the control rod to obtain the setting. (3/8 to
7/16 of an inch on variable Venturi Carbs.)
To perform a high-speed adjustment, attach a tachometer to the engine, then run the engine until
it reaches normal operating temperature.
•
Loosen the locknut on the high speed stop screw.
•
Disengage the engine load.
•
Slowly pull the throttle control to desired maximum no load engine speed.
41