Page 4 | 1-800-343-9463
PT
102417
•
(2) 1/2” x 1/2” 90° nylon barbed fitting
•
(1) 1/2” barbed tee
•
(1) Double-D strain relief
•
(4) 3/4” adhesive cable tie mounts
•
(2) Small cable ties
•
(4) #8 x 13/4” hex-head screws
RECEIVING & INSPECTING THE SYSTEM
Please leave the unit in its original box until you are ready for installation. This will allow you to move the product safely without damaging it.
When you are ready to remove the product from the box, refer to the installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
(1) Filter grille
(1) Duct plenum
Wall-Mounted Master Accessory Kit Box
Ducted Master Accessory Kit Box
•
(1) Master Platinum Split Twin evaporator unit
•
(1) Wall-mounted evaporator installation template
Master Evaporator Box
Condensing Unit Box
•
Use caution when lifting and check package for damage.
•
Lift only at the designated hand-hold locations on the shipping container, or fully support the unit from underneath. A
shipment may include one or more boxes containing accessories.
•
Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.
•
Write any discrepancy or visual damage on the bill of lading before signing.
•
Allow the condensing unit to sit for 24 hours prior to start-up. The condensing unit can be placed in the installation
location, piped, and evacuated during this time.
NOTE: WhisperKOOL units are manufactured in the USA and tested prior to shipment.
•
Review the packing slip to verify contents.
•
Check the model number to ensure it is correct.
•
Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
contact WhisperKOOL Customer Service immediately .
Documentation bag (master)
:
•
Platinum Split Twin owner’s manual
•
Platinum Split Twin technician’s manual
•
R-404a split system warranty checklist
Evaporator installation hardware bag (master)
•
(2) 1/2” x 1/2” 90° nylon barbed fitting
•
(1) 1/2” barbed tee
•
(1) Double-D strain relief
•
(4) 3/4” adhesive cable tie mounts
•
(2) Small cable ties
•
(4) #8 x 13/4” hex-head screws
•
(1) Slave Platinum Split Twin evaporator unit
•
(1) Wall-mounted evaporator installation
template
•
(1) Evaporator installation hardware bag
Slave Evaporator Box
Check all shipped boxes for the following contents:
(1) Duct plenum
Ducted Slave Accessory Kit Box
(1) Filter grille
Wall-Mounted Slave Accessory Kit Box
OR
OR
•
(1) Condensing unit
•
(1) Condensing unit accessory kit:
- (1) 1/4” filter drier
- (1) 1/4” sight glass
