whisker Litter-Robot 3, Инструкция по эксплуатации

Страница: 30 / 40

whiskersupport.com
30
Cleaning the Waste Drawer
1.
Pull the drawer out.
2.
Remove the carbon filter.
3.
Clean the drawer with soap and water.
4.
Make sure the carbon filter is dry before reinstalling it.
Cleaning the Base
●
Never submerge or soak the Base. The Base contains the Cat Sensor and
electronics.
●
Wipe the surfaces of the Base with a cloth dampened with a disinfectant. If
using a spray, spray away from the Base directly onto a cloth or paper towel, so
disinfectant does not get on the electronics.
●
Do not use bleach.
Reinstalling the Globe and Bonnet
See diagrams on the next page.
1.
Place the Globe on the Base in the approximate Home position (black lip of the
opening at the bottom) with the gear track aligned with the groove in the Base.
Note: The rotational axis of the Globe is positioned at a 20-degree angle relative
to the floor, so the Globe is installed slightly tilted in the Base.
2.
Rotate the black Key at the back of the Globe into the pocket of the Base.
3.
Find the tabs at the bottom and rear of the Bonnet. Align and insert the tabs
into slots in the Base.
4.
Rotate the Bonnet downward with light pressure on the sides such that the
Bonnet hugs the Globe. This will help to ensure proper alignment of the Bonnet
snaps with the slots in the Base. Once the Bonnet snaps have entered the slots,
push down on the Bonnet from the top and make sure the Bonnet snaps have
latched into place and the Bonnet is secure.
Note: The unit will not run without the Bonnet installed.