— 5 —
(continued)
W10337809C
22. Plug the 4” hole in the rear panel that the existing exhaust
vent ran through using the metal cover plate included with
kit. Use screw included with kit to secure plate in position.
Install plate from the inside of the dryer rear panel with tab
of plate positioned as shown in Figure 20.
NOTE: As recommended, install cover plate from the inside of
the dryer with tab located at the bottom of the rear exhaust hole.
To aid in installation, take a screwdriver, inserting it into the larger
hole in the cover plate and pulling the plate toward the rear.
NOTE: If dryer was previously setup for bottom venting, from
inside of dryer install the metal cover plate with screw included
with kit to the bottom panel hole that the vent tube previously
existed. See Figure 23.
23. Use screw included with kit to secure plate in position by
driving the retaining screw into the plate’s smaller hole to
lock the plate in position as shown in Figure 21.
figure 21
SCREW HEAD (FASTENS
AGAINST EDGE OF CABINET)
TAB
BOTTOM
OF DRYER
CABINET
REAR
screw heaD (fastens
against eDge of cabinet)
cabinet
rear
tab
bottom of
Dryer
figure 20
tab - plate
cover
plate
outsiDe view
screw
insiDe view
NOTE: If dryer was previously setup for side venting leaving an
exposed knockout hole or had additional panel knockout removed,
from outside of dryer install the plastic plug(s) included with kit to
the side panel knockout hole(s). See Figure 22.
figure 23
screw
cover
plate
24. Verify if electrical tape is located on main wiring harness as
shown in Figure 24. If not, wrap electrical tape as shown
around harness wire lead to prevent possible wire pinching.
figure 24
tape
Fire Hazard
Install cabinet plug(s) before operating.
Failure to follow these instructions can result in
death, fire, electrical shock, or serious injury.
WARNING
figure 22
(3) tabs
