Whirlpool RIHO, Руководство пользователя

Страница: 29 / 68

-27-
Enjoy the RIHO life-style
GB
G
B
Automatic :
If you take a bath and the level sensor is covered with water for 5 minutes, the automatic
will start after the bath is emptied. During the 8 minutes waiting time, the LEDs above the switch
will flash at high speed (twice the normal speed). The aero-motor will then be run for 45 seconds (the LED
will then flash at normal speed)
Attention:
This function may be switched off over a dipswitch at the time of installation.
run-dry function
run-dry function
+
4.1.4 system Run-dry
Manual function:
If one or both buttons are pressed for 2 seconds, when there is “no” water in the bath (level sensor),
on will start up:
The indication LEDs above both the buttons will start flashing
The hydro-motor will be switched on for a few seconds.
The aero-motor will be switched on for 45 seconds.
The motors will stop and the indication LEDs will switch off
The objective is to the system pipelines.
run-dry
the
run-dry functi
clean and dry
!
+
!
!
!
Light pushbutton:
Switch-on only if there is sufficient water.
The light will switch on after pressing the light pushbutton once. The light function will switch off after 20
minutes.
If the light function is on and the water level
(2 seconds), the light function will switch off.
If the light function is switched on and the whirlpool motor is started, the time for the light function will be
set at the running time of the motor + 5 minutes. In other words, after the running of the whirlpool motor is
completed, the light will remain on for another 5 minutes. If the motor is switched off between times, the
light function will switch off 5 minutes later.
The light will switch off after pressing the light button briefly.
drops
Optional Colour therapy:
Only to be switched on when the water level is sufficient.
Pressing the light switch for some time switches the colour therapy function on. The colour therapy
switches off after 20 minutes.
When the light switch is pressed during the colour therapy the colour change will stop, during which the
LED above the key will flash. When you press the button again the colour change will start again. If you
wish to end the function earlier, press the light switch again for some time and the colour therapy will be
switched off.
If the colour therapy is on and the water level gets too low (2 sec) the colour therapy will switch off.
If the colour therapy function is on when the whirlpool motor is started, the time of the light function will be
set to motor r 5 minutes. This means that once the whirlpool motor has switched off, the colour
therapy will stay on for another 5 minutes. When the motor is switched off in the mean time, the colour
therapy function will switch off 5 minutes later.
Whirlpool Electronic - User manual
Aero pushbutton:
Switch-on only if there is sufficient water.
This pushbutton is used to switch the aero system on and off.
On pressing the first time, the motor and the indication LED above the button will switch on.
On pressing the second time, the motor and the indication LED above the button will switch off.
!
!
!
Pressing down on this button will automatically make the system work harder and softer.
!
After this button is released, the system automatically remains turning at the speed at which you
released the button.
!
Press again, the motor and gauge lights go out.
!
When starting again, speed is always high.
Votre revendeur : DUVIVIER sàrl - www.duvivier.lu