Whirlpool RIHO, Руководство пользователя

Страница: 22 / 68

Fig. 3: wall mounting
-20-
G
B
1.5 Bath installation:
As extra protection, place plastic or cardboard on the bottom.
A metal support frame with 4 adjustable legs will be supplied with the bath. The 4 adjustable legs will be provided
separately, depending on the packing method. If necessary, install the 4 adjustable legs (see Fig. 2: leg installation
drawing). With the adjustable legs, ensure that the bath is properly levelled and at the right height and do not forget to
tighten the lock nuts afterwards. Check to ensure that all the legs are resting properly on the floor.
!
!
Fig. 2: leg installation drawing
!
!
Install the overflow-drain combination in the bath. Check whether all the components are properly mounted
according to the attached installation specifications of the manufacturer. The overflow-drain combination bore in the
bath should be Ø52 mm.
The bath may be fixed on the wall with a wooden lath (see Fig. 3: wall mounting) or using the clips provided
(alternative), as shown on the next page. This installation method applies to the installation of the bath against the tiles
(recommended by RIHO) or with the tile edge on the bath edge. (The advantage of installation against the tiles is that in
case of defects in respect of which there is poor accessibility via the inspection hatches, accessibility is still possible by
removing the bath.)
Connect the bath to the drain pipeline. Level the bath properly.
Z1209003.4 GB
A
A
Votre revendeur : DUVIVIER sàrl - www.duvivier.lu