GB 12
Red indication
lights up
(if fitted on your
machine)
Indication on
time display
(if fitted on your
machine)
Description
Causes
Solutions
“Service”
from “F02” to “F35”
(except “F09”)
“Electrical module fault”
Select and start the “Drain” programme or push the
“Reset” button for at least 3 seconds.
“F09”
“Water level too high” (after programme
cancellation or false operating). Switch off the
appliance (by pressing the “On/Off” button or by
turning the programme selector to the “Off/O”
position - depending on the model) and then switch
it on again, select the programme “Drain” and start
within 15 sec.
“FA”
“Waterstop fault”
Switch off the appliance (by pressing the “On/Off”
button or by turning the programme selector to the
“Off/O” position - depending on the model), pull
out mains plug and turn the water tap off. Tilt the
appliance forward carefully to allow collected water
to flow out from the bottom. Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows
into the appliance without the appliance being
started, there is a failure; turn off the tap and notify
the After-Sales Service).
• Select and start the desired programme again.
“Fod”
“Overfoaming”
Too much foam interrupted the wash programme.
• Select and start the “Rinse & Spin” programme.
• Afterwards select and start the desired
programme again, using less detergent.
If any of the faults described above persist, unplug
the appliance, turn off the water tap and contact our
After-Sales Service (see next chapter).
IFU Delta-DoHR-GB.fm Page 12 Wednesday, December 13, 2006 6:04 PM
