2
INSTALLATION
PRIOR TO CONNECTING
C
HECK
THAT
THE
VOLTAGE
on the rating plate
corresponds to the voltage
in your home
.
AFTER CONNECTING
D
O
NOT
REMOVE
THE
MICROWAVE
INLET
PROTECTION
PLATES
located on the side of the oven cavity
wall. They prevent grease & food particles from
entering the microwave inlet channels.
E
NSURE
THAT
THE
APPLIANCE
IS
NOT
DAMAGED
.
Check
that the oven door closes fi rmly against the
door support and that the internal door seal is
not damaged. Empty the oven and clean the
interior with a soft, damp cloth.
I
MPORTANT
!
A
PERMANENT
CONNECTION
REQUIRES
the installation
of a separating device. The separating device
must have an omnipolar contact opening of
more than 3 mm including LS switches, safety
valves and relays. The separating device must
be connected directly to the terminal.
The manufacturers are not liable for any
problems caused by the user’s failure to
observe these instructions.
T
HE
EARTHING
OF
THIS
APPLIANCE
is compulsory.
The manufacturer will accept no responsibility
for injury to persons, animals or damage to
objects arising from the non-observance of this
requirement.
I
N
THE
CASE
OF
A
PERMANENT
CONNECTION
,
the
appliance should be installed by a qualifi ed
technician.
E
NSURE
the oven cavity is empty before
mounting.
D
O
NOT
OPERATE
THIS
APPLIANCE
if it has a damaged
mains cord or plug, if it is not working properly,
or if it has been damaged or dropped. Do not
immerse the mains cord or plug in water. Keep
the cord away from hot surfaces. Electrical
shock, fi re or other hazards may result.
Follow the supplied
separate mounting instructions
when installing the appliance.
T
HE
OVEN
CAN
BE
OPERATED
ONLY
if the oven door is
fi rmly closed.
D
O
NOT
USE
EXTENSION
CORD
:
I
F
THE
POWER
SUPPLY
CORD
IS
TOO
SHORT
,
have a
qualifi ed electrician or serviceman install
an outlet near the appliance.
