Whirlpool 7MWFW5622HW, Инструкция по использованию и уходу

Страница: 47 / 80

47
CONTROL PANEL AND FEATURES
NOTES:
■
Not all features and cycles are on all models.
■
If your model has a touch interface, the control panel features a sensitive surface that responds to a light touch of your finger. To
ensure your selections are registered, touch the control panel with your fingertip, not your fingernail. When selecting a setting or
option, simply touch its name.
■
If your model has physical buttons, make sure to press the button firmly.
■
At cycle completion, your setting and option choices will be remembered for the next cycle. However, if power to the washer is
lost, the settings and options will go back to the factory defaults.
1 2
2
What to Wash
How to Wash
3
Cycles and settings vary by model.
POWER
Select to turn the washer on and off. Select to stop/cancel
a cycle at any time.
WHAT TO WASH/HOW TO WASH
First determine what items are in the load that you are trying
to wash. Use that to guide your “What to Wash” selection.
Then determine how you want the washer to wash them
and make the appropriate “How to Wash” selection.
See “Cycle Guide” for cycle details. If you do not make a
“How to Wash” selection, the washer will automaticlly select
the recommended or last-used “How to Wash” cycle.
START/PAUSE
Touch and hold for 3 seconds until the light above START/
PAUSE comes on to start a cycle, or touch once while a
cycle is in process to pause it.
CYCLE STATUS DISPLAY
The Cycle Status Display shows the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
1
2
3
4
Estimated Time Remaining
The Estimated Time Remaining shows the time required for
the cycle to complete. Factors such as load size, modifiers,
options selected, and water pressure may affect the time
shown in the display. Tightly packed loads, unbalanced loads,
or excessive suds may cause the washer to lengthen the
cycle time as well.
Sensing
When START/PAUSE is touched the washer will chime,
indicating it is starting. The drum will make a partial turn.
The door will click when it locks.
Once the door has locked, the washer will begin spinning
to sense the load size. This sensing process will continue
throughout the cycle.
After the load size is sensed, the estimated time based
on load size will be displayed and water will be added.
You may hear water flowing through the dispenser,
adding detergent to the load. The actual cycle time may
be lengthened; however, the display will continue to show
the estimated time.
4
7
5
hold 3 sec for
Cycle Signal
hold 3 sec for
Control Lock
hold 3 sec for
FanFresh
hold 3 sec for
PreSoak
6